HiLL Hallo zusammen, ich bin grade dabei Arch (.72) als zweit Betriebssystem zu installieren. Ich habe jetzt allerdings folgendes problem: Ich habe den Xserver ganz unspektakulär via pacman -S xorg installiert und dananch mit hwd -x die xorg.conf erstellt. Während der Installation vom xorg bekamm ich noch ene meldung das irgendwas mit den fonts wäre, dass hat mich allerdings nicht großartig beschäftigt da die Installtion nicht abbrach. Anschliesend habe ich xfce4 installiert. Wenn ich xfce starte dann kommt recht schnell nach dem start (bevor die Menüleisten da sind) folgende Meldung: Could not look up internet address for myhost. This will prevent Xfce from operating correctly. It may be possible to correct the problem by adding myhost to the file /etc/hosts on your system. Muss ich hier noch zusätzlich zum loopback die Netzwerkdaten vom meinem Notebook eintragen? Und warum will das denn mein xfce? So wenn ich nun fluxbox starten will bekomm ich folgendes zu hören bzw zu sehen 🙂 : Warning: Failed to set locale, reverting to "C" terminate called after throwing an instance of 'std::string' /root/.fluxbox/startup: line 12: 3510 Aborted /usr/bin/fbsetroot -solid black Warning: Failed to set locale, reverting to "C" Error: Couldn't connect to XServer So zu wenn ich den befehl startx eingeben bekomm ich folgende Meldung: The XKEYBOARD keymap compiler (xkbcomp) reports: > Warning: Type "ONE_LEVEL" has 1 levels, but <RALT> has 2 symbols > Ignoring extra symbols Errors from xkbcomp are noct fatal to the X server /etc/X11/xinit/xinitrc: line 28: twn: command not found /etc/X11/xinit/xinitrc: line 29: xclock: command not found /etc/X11/xinit/xinitrc: line 30: xterm: command not found /etc/X11/xinit/xinitrc: line 31: xterm: command not found /etc/X11/xinit/xinitrc: line 32: exec: xterm: not found waiting for X server to shut down FreeFontPath: FPE "/usr/share/fonts/misc:unscaled" refcount is 2, should be 1; fixing. Kann mir jemand helfen und sagen was ich tun muss damit mein Arch ganz braf und anständig läuft? Danke schon für jede Hilfe! Gruß HiLL
Pierre Ist Dein hostname unter /etc/hosts eingetragen? Was gibt ifconfig aus? Zu den locales siehe hier.
HiLL Also ich habe jetzt die locales eingerichtet und mein Hostname in die /etc/hosts eingetragen. Es hat sich aber noch nicht viel getan, außer das ich jetzt als root den xserver via startx starten kann. Als normaler user geht das aber nicht. Die (Fehler)Meldung von XFCE kommt auch nicht mehr. Habe aber immer noch das Problem mit fluxbox.