Hallo zusammen,
ich bin langsam mit meinem Wissen am Ende, evtl kann mir hier jemand weiterhelfen.
Ich habe ein Schenker S306 Laptop mit Arch Linux und systemd-boot UEFI und sobald ich den Netzstecker ziehe flackert das Bild so sehr, dass man nicht mehr mit dem Laptop arbeiten kann.
Ich hab versucht die module option
i915.enable_psr=0 zu setzen, aber scheinbar ohne Erfolg.
Hier noch ein paar details die evtl hilfreich sein könne, wenn mehr benötigt wird, einfach nachfragen.
lspci -v
00:02.0 VGA compatible controller: Intel Corporation Skylake GT2 [HD Graphics 520] (rev 07) (prog-if 00 [VGA controller])
DeviceName: Onboard IGD
Subsystem: Intel Corporation Skylake GT2 [HD Graphics 520]
Flags: bus master, fast devsel, latency 0, IRQ 124
Memory at de000000 (64-bit, non-prefetchable) [size=16M]
Memory at c0000000 (64-bit, prefetchable) [size=256M]
I/O ports at f000 [size=64]
Expansion ROM at 000c0000 [virtual] [disabled] [size=128K]
Capabilities: [40] Vendor Specific Information: Len=0c <?>
Capabilities: [70] Express Root Complex Integrated Endpoint, MSI 00
Capabilities: [ac] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [d0] Power Management version 2
Capabilities: [100] Process Address Space ID (PASID)
Capabilities: [200] Address Translation Service (ATS)
Capabilities: [300] Page Request Interface (PRI)
Kernel driver in use: i915
Kernel modules: i915
systool -m i915 -av
Module = "i915"
Attributes:
coresize = "2662400"
initsize = "0"
initstate = "live"
refcnt = "15"
srcversion = "00087F91654940B25FA7044"
taint = ""
uevent = <store method only>
Parameters:
Sections:
cat /boot/loader/entries/arch-uefi.conf
titel Arch Linux
linux /vmlinuz-linux
initrd /initramfs-linux.img
options root=LABEL=arch rw resume=LABEL=swap i915.enable_psr=0
cat /etc/mkinitcpio.conf
MODULES=(i915)
BINARIES=()
FILES=()
HOOKS=(base udev autodetect modconf block filesystems keyboard fsck)
cat /etc/modprobe.d/i915.conf
options i915 enable_psr=0
modinfo -p i915
...
enable_psr:Enable PSR (0=disabled, 1=enabled) Default: -1 (use per-chip default) (int)
psr_safest_params:Replace PSR VBT parameters by the safest and not optimal ones. This is helpful to detect if PSR issues are related to bad values set in VBT. (0=use VBT parameters, 1=use safest parameters) (bool)
...
Bin für jede Hilfe dankbar!