Das mit dem cryptsetup kenne ich 😉 die kernel Zeit Schwank je nach dem wie schnell ich beim Passwort eintippen bin.
systemd-analyze
Startup finished in 13.872s (kernel) + 2.075s (userspace) = 15.948s
systemd-analyze blame
950ms NetworkManager.service
390ms upower.service
387ms avahi-daemon.service
385ms systemd-logind.service
266ms systemd-tmpfiles-setup.service
235ms iptables.service
195ms systemd-udev-trigger.service
183ms systemd-vconsole-setup.service
163ms polkit.service
154ms sys-kernel-debug.mount
154ms dev-hugepages.mount
152ms kmod-static-nodes.service
151ms systemd-sysctl.service
147ms systemd-modules-load.service
133ms dev-mqueue.mount
126ms tmp.mount
126ms systemd-remount-fs.service
95ms alsa-restore.service
84ms systemd-fsck@dev-disk-by\x2duuid-....service
81ms udisks2.service
44ms user@1000.service
36ms wpa_supplicant.service
33ms systemd-tmpfiles-setup-dev.service
32ms systemd-journal-flush.service
22ms ntpd.service
19ms systemd-random-seed.service
18ms sys-kernel-config.mount
17ms systemd-user-sessions.service
13ms dev-disk-by\x2duuid-....swap
11ms boot.mount
8ms systemd-udevd.service
7ms systemd-update-utmp.service
6ms lvmetad.service
Und ich denke das wichtigste wenn man den schuldigen für die lange Bootzeit such:
systemd-analyze critical-chain
The time after the unit is active or started is printed after the "@" character.
The time the unit takes to start is printed after the "+" character.
graphical.target @2.074s
└─multi-user.target @2.073s
└─ntpd.service @2.051s +22ms
└─network.target @2.047s
└─NetworkManager.service @1.096s +950ms
└─basic.target @1.093s
└─timers.target @1.089s
└─systemd-tmpfiles-clean.timer @1.087s
└─sysinit.target @1.087s
└─systemd-update-utmp.service @1.079s +7ms
└─systemd-tmpfiles-setup.service @753ms +266ms
└─local-fs.target @752ms
└─boot.mount @741ms +11ms
└─systemd-fsck@dev-disk-by\x2duuid-....service @653ms +84ms
└─dev-disk-by\x2duuid-....device @653ms
Bis zum graphical.target wüste ich nicht was ich noch optimieren kann. Aber KDE brauch auch danach noch einiges an Zeit und da versuche ich derzeit noch was herauszuholen. (Ja ich weiß dass eine anderer Desktopumgebung da der einfachste weg wäre. Aber ich man nun mal KDE am liebsten).
Aber insgesamt sind cryptsetup und KDE keine Kandidaten für Rekorde bei der Bootzeit. :rolleyes: